Scary Weave

Relax, nothing scary here, just 2 new bracelets made in Scary Weave pattern. This is in response to Maillers Worldwide's July 2010 challenge.

I had wanted to try the weave for some time now; earlier attempts didn't go far; I had a hard time placing the connector rings. Base on the tutorial, I think it's meant to form a 3-tier step up or down, depending on how you look at it. But some photos of finished work out there show either a peak/valley style or multiple-ring-connection. I don't know which is which... They all look nice to me:-) Mine followed exact steps of the tutorial, and I must say, it's easier said than done. The Honey Bee connection was much easier.

Any who, here are the specs:

Copper and stainless steel square wire rings from C&T, 20-K, 0.8 mm x 0.8 mm, AR sized for HP4-1, so about 5ish. The stainless steel rings' AR seems wee bit smaller than copper; my attempt to make a "copper orbital on one side, steel the other" didn't work... it only flexed to the steel side. Photographed here is the remake on the copper/steel mix; it only comes up half a unit shorter than the all copper one.

RPI: This one measured 3 units per inch, so that makes it 21 rings per inch.

The heart clasp together with the catch rings are hand forged from 1.3 mm copper wire. I'm getting to be quite good at this:-)

The matching earrings came from extra units of the all copper bracelet; the ear wires are from 1.0 mm Niobium, handmade then anodized.

Enjoy the slide show!